39 | Chapter 1 : DVR User Manual
3.2.6
PTZ
If you wish to connect a PTZ camera to the VMAX HD, use this setup menu to connect it.
To setup a PTZ Camera:
1.
Connect an RS-485 cable from the camera’s board to the back of the DVR (See section
1.5
Rear Panel
for more information).
2.
In the DVR, go to Menu
Device
PTZ.
3.
Select the Channel you want to setup as a PTZ camera.
4.
Select the camera’s protocol from the drop-down list.
5.
Setup the corresponding speed. Select from 19200, 14400, 9600, 4800, or 2400 Baudrate.
6.
Select the matching ID of the PTZ Camera from the drop-down list. Select from 0~63.
T
ROUBLESHOOT
Camera Connection
If you cannot control your PTZ camera, try the following:
1.
Check if the protocol set in the DVR is the same as used in the camera.
2.
Check if the baud-rate set in the DVR is the same as used in the camera and that it is
in accordance with the assigned value for that PTZ protocol.
3.
Check if the address of the camera is correct.
4.
Check if the wiring is correct and the wires are not damaged.
If the problem persists, consult your PTZ camera’s manual for additional information.
