DW-CP04 Manual
01Manual_CP04_05172013
49
8.3. Camera & Motion
This menu is used to set up the recording video format, data added to video data, encoding speed,
audio control, image resolution, video quality, motion detection, etc.
Click
Camera & Motion
on Device Configuration menu to open the configuration page as seen below:
Video with Flexible Extra System data
: If
Enabled
, recorded video will contain Flexible
Extra Data from COM port.
Video with user defined message:
If
Enabled,
recorded
video will contain the user-defined
data. (Reserved Field)
Video with PPP status
: If
Enabled
, recorded video will contain PPP connection status.
Video with camera name
: If
Enabled,
recorded video will contain camera’s name.
Video with server name
: If
Enabled
, recorded video will contain server’s name as defined by
the user.
Video with IP address
: If
Enabled
, recorded video will contain the IP address of the server.
Audio
: Select if Audio function is to be used (applies to Primary Stream only). DW-CP04
supports 2-way audio streaming by combining microphone input with video data. Users can listen
to the streamed audio on PC speakers.
Image Size
: Select the resolution of each channel’s video
Frame Rate
: Adjust the number of frames per second the channels are recording.
Encoding Standard
: Select the compression method of each video, either MJPEG or H.264
format. Both streams cannot be set to MJPEG
o
H.264
: In this format, each frame data is related to other nearby frames. For this reason, it
provides much higher compression ratio than MJPEG and is adequate for video transfer.
However, if network condition is not very good and frames may drop, the video quality can
be relatively low.
o
MJPEG
: This format requires much higher network bandwidth than H.264 compression.
But because of its higher quality of still image, it is adequate for detailed reviewing of
stored video.
To save the setting, click
Apply
button.
