DW-CP04 Manual
01Manual_CP04_05172013
16
3. DW-CP04 Installation and Basic Setup
3.1. Before Installation
Read carefully User's Manual.
Check u
ser’s Network (IP Address, Network Mask and default gateway)
Secure an IP address for DW-CP04.
3.2. Factory Default Settings
The following table shows the factory default condition for the Compressor. Please refer to this when
you need to change the values on the admin menu.
Factory Default
Admin ID
root
Admin password
root
IP address
10.20.30.40
Network mask
255.255.255.0
Gateway
10.20.30.1
Table 5: Factory Default
Note: Factory default Admin ID and Password are all lower case letters.
3.3. Installing the DW-CP04
For installation of DW-CP04, please follow the steps below.
1. Place the analog cameras in place and connect power supplies.
Consult the cameras’ manual
for additional information.
2. Connect the video output ports of the analog cameras to the video-in ports of the DW-CP04.
3. Connect the DW-CP04 to the desired network by connecting
a network cable to the encoder’s
LAN port.
4. Connect the power supply of DW-CP04. To prevent any damage to the device, it is
recommended to plug the power cables to the power supply and only then to the Compressor.
5. Once both LEDs are on you can connect to the DW-
CP04’s web viewer. (Power LED should
appear orange, and LAN LED should appear green).
6. To find the Compressor on the network as well as configure its network settings, run the IP
Installer tool available on the complimentary CD accessory.
