Digital Projection TITAN XG-500, User Manual

Page: 99 / 120

Rev C March 2008 Page 7.3
Digital Projection TITAN XG-500 User Manual 7. Appendix
Problem Possible solutions
Projector does not respond to control
commands from a computer. Check that the LAN or serial cable is connected correctly.
See this section 7. Appendix, Connections
If using a LAN, check that the address setting is made correctly.
See section 4. Controlling the projector, Network menu
If using a serial cable, check that the baud rate is set correctly.
See this section 7. Appendix, Connections
Check that the correct control codes are being used.
See Serial communications protocol (available from Digital Projection)
Projector does not respond to control
commands from the remote control. If you are using a cable, check that the cable is connected properly at both ends,
that the cable is not damaged and that the cable is no longer than 50m (150ft).
If you are not using a cable, check that the infra red windows at the front and rear
of the projector are not obstructed. Check that the cable is disconnected from
the projector, as this disables the infra red. Check that the batteries are in good
condition.
Check that the address setting on the remote control is set either to zero, or to the
same as the projector.
See section 4. Controlling the projector, Communication menu
In the event that this troubleshooting guide has not solved the problem,
then contact your Digital Projection dealer or service centre.