Page 4.38
Rev C March 2008
4. Controlling the projector
Digital Projection
TITAN XG-500
User Manual
Notes
Setup Menu
On Screen Display
The
On Screen Display
will
move to the centre of the DMD
when
Blanking
is turned
On
.
(see
Geometry menu
, earlier in
this section).
If a menu is opened, and no
other key is pressed within the
period set in the
OSD Timeout
menu, then the menus will
disappear. When the
key
is pressed again, the menus will
reopen at the same point they
were last viewed.
On Screen Display
Press
and
to select On Screen Display.
Press
to open the On Screen Display submenu.
OSD Position
Press
and
to select OSD Position
Press
and
to select from:
Upper Left
Upper Centre
Upper Right
Middle Left
Middle Centre
Middle Right
Lower Left
Lower Centre
Lower Right
OSD Size
Press
and
to select OSD Size.
Press
and
to select from:
Large
Small
OSD Timeout
Press
and
to select the length of the On Screen Display Timeout.
Press
and
to select from:
0 to 255
in 1 second steps
(when set to zero, the OSD never times out)
•
•
•
•
Setup menu continued
Summary of Contents for TITAN XG-500
