Digital Projection TITAN XG-500, User Manual

Page: 35 / 120

Rev C March 2008 Page 2.15
Digital Projection TITAN XG-500 User Manual 2. Installation
Notes
When stacking projectors,
the stack MUST be vertical,
to ensure that the stresses
are distributed to all frame
couplings.
Make sure that the surface,
ceiling or rigging that is
to support the projector is
capable of supporting the
combined weight of all the
projectors and lenses
(see
speci fi cation for weights) .
Do not place heavy objects
on top of the projector
chassis. Only the chassis
corners and the rigging frame
are capable of withstanding
the weight of another
projector.
Do not try to stack more than
3 projectors.
Separate backup safety
chains or wires should
always be used for each
projector.
Stacking projectors
The rigging frame is capable of supporting the weight of up to two other projectors,
using the built-in frame couplings. The projectors can be stacked on top of each
other, or suspended below each other.
Carefully lower each projector down onto the top of the others, making sure that
all four frame couplings engage fully.
Fit a locking pin into each coupling. A ball in the end of the pin prevents the pin
from falling out – to insert or remove a locking pin, press the button on the end of
the pin to release the ball.
Align the images from the projectors, following the instructions on the previous
page and those in
section 3. Getting started , Adjusting the lens and
Adjusting the projected image .
•
•
•
Locking
pin
Frame
couplings