Digital Projection TITAN XG-500, User Manual

Page: 55 / 120

Rev C March 2008 Page 4.13
Digital Projection TITAN XG-500 User Manual 4. Controlling the projector
Notes
The red, green and blue keys
are disabled when the OSD is
switched OFF.
The Saturation control is
available for Composite, S-
Video and Component inputs
only.
The Phase control is available
for RGB inputs only.
For all adjustments on this page
that require more than one key
to be pressed:
- after 10 seconds, if no
adjustment has been made, the
key must be pressed again
to resume adjustment.
- to end the adjustment before
10 seconds has elapsed, press
a different adjustment key, or
press the key.
When the OSD is OFF:
- the keys will still function,
but the controls will not be
visible on screen.
Red, Green and Blue
Press , or to switch the red, green or blue components OFF
or ON.
Test pattern
Press to select a test pattern.
Picture settings
Press a key, followed by and to adjust these picture settings:
Brightness BRI
Contrast CON
Saturation SAT
Phase PHASE
Aspect ratio ASPECT
Geometry settings
Keystone adjustment is used to correct for distortion caused by the projector being
mounted higher or lower than the screen.
Press Keystone KEYST,
followed by and to adjust the keystone correction:
Press Position POS,
followed by , , and to adjust the picture position, for images
smaller than the DMD:
•
•
•
•
•