Page 4.40
Rev C March 2008
4. Controlling the projector
Digital Projection
TITAN XG-500
User Manual
Notes
Setup Menu
Comunication
When fresh batteries are
inserted in the remote control,
it will default to address
00
.
Remote control
00
is a
master
control, able to control all
projectors.
FIf two or more projectors are
set to the same address, they
can be controlled from one
remote control, provided they
are connected by cable or in
range of the infra red.
Communication
Press
and
to select Comunication.
Press
to open the Comunication submenu.
Projector Address
The projector and the remote control need to be set to matching addresses. Read
the note to the right on this page, and follow the instructions in the order shown
below:
1
Set the projector address:
Press
to open the Projector address control box.
Press
and
to select the address setting.
Press
and
to adjust the address from:
00 to 99
Use
and
to select from
Apply
Press
to apply the new Projector Address.
or Cancel
Press
or
to exit without making the change.
2
Set the remote control address as shown in
Using the control keys
, earlier in
this section.
•
Setup menu continued
Summary of Contents for TITAN XG-500
