Digital Equipment LGplus Series, Setup Manual

Page: 30 / 194

2–8
Remove the Platen Protective Foam
Tractor Locks
Platen Protective Foam
Tractor Door
Forms
Thickness
Lever
Support Shaft
Tractor Door
Figure 2–4. Removing the Platen Protective Foam
1. Open the tractor doors. Push the tractor locks down. Slide the tractors
outward as far as they will go. (See Figure 2–4.) The forms thickness
lever should be in the fully open position.
2. Rotate the platen protective foam toward the front of the printer and out
from under the support shaft. Remove the platen protective foam.
3. Remove the envelope that contains the sample configuration printout.
Store this in the pouch that is attached to the right interior side of the
cabinet.