Digital Equipment LGplus Series, Setup Manual

Page: 186 / 194

Index–2
data strobe, 5–7
online, 5–7
paper empty, 5–7
paper instruction (PI), 5–7
Centronics parallel menu, 4–42
Chains, paper, 2–10
Changing parameters, 3–12
Character Set, U.S. ASCII, B–1
Character sets, Epson emulation, 4–25
Cleaning requirements, 6–2
CLEAR PAPER JAM, 6–12
Clear to send (CTS) signal, RS–232 serial
interface, 5–16
CLOSE PLATEN, 6–12
Code chart, U.S. ASCII, B–1
COIL HOT, 6–13
Communication, bidirectional (1284), 5–9
Communication, Dataproducts parallel, 5–3
Compatibility mode, 5–9
Configuration
Centronics parallel interface, 5–8
changing parameters, 3–12
Dataproducts parallel interface, 5–5
factory default values, 3–10
loading configuration values, 3–19
menu, top level, 3–4, 3–5, 4–6, 4–19
power–up selection, 3–21
printout, 3–17
RS–232 serial interface, 5–18
RS–422 serial interface, 5–18
saving, 3–15
saving parameters, 3–6
terminating resistors, 5–13
Configuration menus
Centronics parallel, 4–42
Dataproducts, 4–45
serial interface, 4–38
Configurations, types of, 3–7
Configuring printer, 3–2
Connections, cable, 2–11
Connectors for host interface cables, 2–12
Control codes, overview description, 1–8
Control codes and control panel changes, 3–6
Control panel keys, 3–8
CR = CR, 4–23
CR = CR + LF, 4–23
CTL VOLT FAIL *, 6–13
D
Data Bit 8 parameter
Centronics submenu, 4–43
Dataproducts, 4–46
Data Bits parameter, 4–40
Data carrier detect (DCD) signal, RS–232
serial interface, 5–16
Data lines 1 through 8 signal
Centronics parallel interface, 5–7
Dataproducts parallel interface, 5–4
Data Polarity parameter, Centronics (parallel)
submenu, 4–43
Data polarity parameter, Dataproducts, 4–46
Data protocol, 4–39
Data Request polarity parameter, 4–46
Data set ready (DSR) signal, RS–232 serial
interface, 5–16
Data strobe signal
Centronics parallel interface, 5–7
Dataproducts parallel interface, 5–4
Data terminal ready (DTR) signal, RS–232
serial interface, 5–16
Data Terminal Ready parameter, 4–40