Hercules III User Manual Rev A.2
www.diamondsystems.com
Page
11
Caution! Be sure the
PS-12V-01
AC power adapter is disconnected
from its AC power source prior to performing the following step.
3.2
System Setup
This section outlines a simple process for preparing Hercules III for first-time operation using the Hercules III
Development Kit. Additional details regarding Hercules
III’s interface functions and connections may be found in
Section 6 of this document (Connectors).
3.2.1
Unpacking
Unpack and remove the Hercules III single board computer from its packaging.
3.2.2
Mounting Kit
Install the four standoffs found in the mounting kit (MTG104) into the four PC/104 mounting holes located on the
board. This ensures that the board will not touch the surface beneath it, and helps redistribute the force when you
push connectors onto the board.
3.2.3
Keyboard and Mouse
Hercules III supports operation using a PS/2-based keyboard and mouse devices. Plug the keyboard and mouse
connectors into the appropriate connectors on the Main I/O cable in the Hercules III Cable Kit (cable number
6981022). Connect the end of the cable into connector J16 on Hercules III.
3.2.4
mSATA Flashdisk Socket
Hercules III provides a location for on-board installation of an optional mSATA flashdisk on connector J35. Plug
the mSATA flashdisk module in the Development Kit into connector J35 on Hercules III. Remove the screw from
the mounting stand-off before installing the flashdisk. Secure the flashdisk to Hercules III with the screw once the
flashdisk is installed.
3.2.5
Mass Storage Devices
If desired, connect SATA hard drives to Hercules III by connecting a SATA cable to SATA connector J4 and then
to the SATA drive. Hercules III can operate with a combination of SATA and CD-ROM drives, and can boot from
either of them.
3.2.6
Connecting Power
Connect cable 6981015 to the PS-12V-01 AC power adapter or an ATX power supply. Connect the other end of
the 6981015 cable to connector J33 on the Hercules III SBC.
3.2.7
Display
Hercules III provides interfaces for both LVDS flat panel displays and VGA output. Connect the VGA cable,
6981024, between the VGA connector, J25, and a VGA-compatible display.