MCQ-PRO RFID Reader
— Installation and Tuning Manual Version 1.00
Page 86 of 89
Use “Message Format” tab checkboxes to choose which fields should be sent.
You can customize text fields by entering the text of your choice as ASCII beside
checkboxes. To enter a non-printable character, enter “\xx” (without quotes) where xx is the
ASCII code of the character as a hexadecimal byte.
11.1.2
Miscellaneous Parameters
This tab contains various standalone mode parameters.
Figure 71: Standalone Mode panel (Misc Parameters tab)
Watchdog
The watchdog permits sending periodically a custom frame on serial port.
You can configure the period used and the message to send in “Watchdog”.
Interframe Delay
If the device in standalone mode is connected to a slow legacy system, it may be necessary to
slow down frame rate to avoid flooding it.
You can configure the delay between each frame sent by device in “Interframe Delay”.
11.2
Enabling standalone mode
To enable standalone mode, click
button in embedded toolbar of
“Standalone Mode Configuration” panel. Click this button again to disable standalone mode.
In standalone mode, the device loads radio configuration from its non-volatile
memory (NVRAM) when it is turned on. Consequently, you should save current
radio configuration to NVRAM before enabling standalone mode. Dialoc ID
MCQ-Pro proposes you to do so when enabling standalone mode. See section
0
to perform this operation manually.
Summary of Contents for MCQ-PRO
Page 1: ...User Manual Version 1 00...
