diagenode BioAcc-cool, Operation Manual

Page: 13 / 60

Introduction
Chapter 1 OPERATION MANUAL
V1.1.0en/13.12.12
Errors and omissions excepted. Water Cooler
13
Improper use
SERIOUS INJURY AND PROPERTY DAMAGE
Store the operation manual where it is easy to access in close proximity to the temperature con-
trol unit.
Only adequately qualified operators may work with the temperature control unit.
Operators must be trained before handling the temperature control unit.
Check that the operators have read and understood the operation manual.
Define precise responsibilities of the operators.
Personal protective equipment must be provided to the operators.
Strictly heed the safety instructions of the operator in order to protect life and limb and limit
property damage.
W01
Modifications to the temperature control unit by third-parties
DAMAGE TO THE TEMPERATURE CONTROL UNIT
Do not allow third parties to make technical modifications to the temperature control unit.
Every modification not agreed with the manufacturer invalidates every CE Declaration of Con-
formity for the temperature control unit.
Only specialists trained by the manufacturer may carry out modifications, repairs or maintenance
work.
The following must be observed without fail:
Only use the temperature control unit in a fault-free condition!
Have start-up and repairs carried out only by specialists!
Never omit, bypass, remove or deactivate safety devices!
H01
The temperature control unit must not be used for any purposes other than temperature control in
accordance with the operation manual.
The temperature control unit is manufactured for industrial use. The temperature control unit main-
tains the temperature of certain applications, including glass or metal reactors or other expedient
items in laboratories and industry. Flow-through coolers and calibration baths must be used only in
combination with Huber temperature control units. Thermal fluids suitable for the overall system
are used. The chilling and heating capacity is provisioned at the pump connections or - where pre-
sent - in the tempering bath. The technical specification of the temperature control unit is given in
the data sheet (from page 55 in section
»Annex« ). The temperature control unit must be installed,
configured and operated according to the handling instructions in this operating manual. Failure to
comply with the operation manual is deemed improper use. The temperature control unit conforms
to state-of-the-art technology and the recognized safety regulations. Safety devices are built into
your temperature control unit.
1.1.3 Reasonably foreseeable misuse
Use with medical devices (e.g. in Vitro diagnostic procedure) or for direct foodstuff temperature
control is
NOT permissible.
The temperature control unit must
NOT be used for any purposes other than temperature control in
accordance with the operation manual.
The manufacturer accepts
NO liability for damage caused by technical modifications to the tem-
perature control unit, improper handling or use of the temperature control unit if the operation
manual is not observed .
WARNING
NOTE
.