diagenode BioAcc-cool, Operation Manual

Page: 36 / 60

Setup mode
OPERATION MANUAL Chapter 4
Water Cooler
Errors and omissions excepted. V1.1.0en/13.12.12
36
4.1 Setup mode
Moving the temperature control unit during operation
SERIOUS BURNS/FREEZING OF THE HOUSING PARTS/ESCAPING THERMAL FLUID
Never move temperature control units that are in operation.
V08
4.1.1 Turning on the temperature control unit
PROCEDURE
Turn on the temperature control unit at the >Mains switch< [37].
The circulation and temperature are switched off.
4.1.2 Setting the setpoint
Changing the preset temperature
PROPERTY DAMAGE
Don't change the preset temperature.
PROCEDURE
Turn on the temperature control unit at the >Mains switch< [37].
Press the >SET key< and hold it down. The setpoint is displayed.
Set with the desired setpoint using the >Arrow keys< .
(up), the temperature increases, (down), the temperature decreases.
Release the >SET key <. The new setpoint is set.
4.2 Filling, venting, off-gassing and draining
4.2.1 Externally open application
4.2.1.1 Filling and venting externally open application
Non-compliance with the safety data sheet for the thermal fluid to be used
INJURIES
Risk of injury to the eyes, skin, respiratory tract.
The safety data sheet for the thermal fluid to be used must be read prior to use and its contents
respected.
Observe the local regulations/work instructions.
Wear your personnel protective equipment (e.g. temperature-resistant safety gloves, safety gog-
gles, safety footwear).
Risk of slipping on dirt on the floor and around the workplace.
V07
CAUTION
NOTE
.
CAUTION