DHS Systems 1003080, Technical Manual

Page: 8 / 136

Operation & Maintenance Medium SXGA+ Projection System
Part Number 1006380 f DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
WARNING
HIGH VOLTAGE is produced when this unit is in operation. Death or severe burns may result if personnel fail
to observe safety precautions.
WARNING
To avoid possible electrical shock, do not remove grounding cable until signal cables and primary power
cables have been disconnected.
WARNING
Remove all rings, watches, and other jewelry when performing maintenance on this equipment. Secure all
loose fitting clothing to prevent from being caught in moving or rotating parts. Death or loss of limb may
result.
WARNING
Do not attempt to service or otherwise make any adjustments, connections or reconnection of wires or cables
until J series Front/Rear Projection System is shut down and completely de-energized. Death
or severe
burns may result.
WARNING
Trichlorotrifluoroethane, trichloroethane, and similar chemical solvents threaten public health and the
environment by destroying ozone in earth’s upper atmosphere. Use only nonhazardous cleaning material
such as a white clean cloth, water, and mild detergent.
WARNING
The screen surface must be stored in its pouch when not in use to prevent damage and discoloration.
While in storage, avoid extreme temperature conditions. If surface becomes sticky, see cleaning
instructions (WP 0016). If stored at temperatures far below room temperatures, allow the screen to
warm up to room temperature before unfolding. This will ensure the film is being handled in its most
flexible state and will prevent surface cracks.