DHS Systems 1003080, Technical Manual

Page: 50 / 136

Operation & Maintenance Medium SXGA+ Projection System 0006
Part Number 1006380 0006-2 DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
JOINING MULTIPLE SCREENS PROCEDURES
WARNING
Each screen surface must be stored in its pouch when not in use to
prevent damages. If stored at temperatures far below room
temperatures, allow the each screen to warm up to room temperature
before unfolding. This will ensure the film is being handled in its most
flexible state and will prevent surface cracks.
WARNING
There are seventeen pivot (pinch) points located around each frame
assembly.
Assemble Frame
Assemble each frame that will be joined together for a multiple screen display in accordance with Assembly
Procedures in WP 0005. Once the required number of screen frames has been assembled, follow the steps below for
joining the multiple screens together.
1. Using the Straight Joining Deluxe Clamp (16) supplied with each system, join screen frames (1) together side by
side as shown in Figure 2.
2. Position the Straight Joining Deluxe Clamp (16) on the back side of the screen frame (1) near the upper and lower
corners of the screen (see Figure 2).
3. Attach Projector to the Projector Support Arm in accordance with WP 0005.
4. Attach Screen to Frame Assembly in accordance with WP 0005.