DH Instruments PPC2+, Manual

Page: 61 / 166

PPC2+™ Operation and Maintenance Manual
Page 53
©2001 DH Instruments, Inc.
The next display is:
1. Entry field for the file number of the sequence to
be edited.
Enter the desired sequence file number.
?Z^Y]O[_OXMOPSVO]MKXLO]O^_ZKNN\O]]X_WLO\]^R\Y_QR
The next selection determines the RPT that will be used:
1. Indication of the sequence file number that is currently
being edited.
Select the RPT that is to be used by this sequence.
The next selection specifies the range of the
selected RPT that is to be used for this sequence:
Select the range (see Section 3.1.2.5) that is to be used when running this sequence.
The next selections specify the pressure unit and
measurement mode in which the sequence
pressure target pressures will be defined:
3P ^RO <:> ]OVOM^ON PY\ ^RO ]O[_OXMO S] K QK_QO <:> 1BBBB ^RO WOK]_\OWOX^ WYNO
]OVOM^SYXaSVVXY^LOYPPO\ONK]QK_QO<:>]MKXYXVcWOK]_\OSXQK_QOWYNO
Press [ENTER] to proceed to the pressure unit and measurement mode selection.
These will operate in the same manner as when the UNIT function is used (see
Section 3.2.2). To change the pressure units available, press [SPECIAL] and select
<3PresU> (see Section 3.4.3).
The next selection specifies the number of pressure targets in the sequence, including
zeros and vents:
1. Entry field to edit the total number of targets in the
sequence including zeros and vents.
Enter the total number of targets in the sequence.
nn
1Hi 2Lo Seq01
3Rng3 Seq01
<Next Screen> Seq01
11 Seq01