Troubleshooting
Is the knob loosened?
Switch off the power by holding down the [Power/Movement]
button for one second or longer.
If the knob becomes loose during imprinting in the event that
the head cap is not used, the head position will not match the
surface height of the material. When you set the head position,
make sure to tighten the knob firmly.
The Machine Doesn't Run Even When Imprint Data Is Sent.
Is the power switched on?
Make sure the Power/Movement button light is on. If it is dark,
press the Power/Movement button to switch on the power.
P. 32 "Switching On the Power"
Is the power cord connected
correctly?
If it is not connected correctly, connect it properly.
P. 31 "Connecting the Machine to a Computer"
Is the cable used for the
connection to the computer
connected correctly?
Check if the connection cable is disconnected.
You Cannot Select the Material of the Object to Be Imprinted Using METAZAStudio.
Is the [Use printer driver set-
tings] checkbox checked?
If the [Use printer driver settings] checkbox is checked in the
[Select Material] dialog box displayed directly after METAZAStu-
dio starts, you cannot select a material. Uncheck the [Use printer
driver settings] checkbox.
Are you using a file created
by an older version of
METAZAStudio?
You cannot select a material using a file created by METAZAStudio
with a version earlier than 2.00. Save the file using METAZAStudio
with a version of 2.00 or later, and select a material.
You can check the version of your METAZAStudio on the window
displayed by clicking the [Help] menu
→
[About] in METAZA-
Studio.
4
Trouble
-
shooting
119
