Imprinting
E
Attach a head cap to the tip of the head.
Mount it while lightly holding the head as shown in the figure. The head cap is attached correctly
when its tab clicks.
Head
cap
Head
Hold the head.
Precautions for use of head cap
Remove dirt and dust from the imprint surface.
If you perform imprinting without removing dirt and dust attached to the printing surface, it may deteriorate
the imprint quality. Make sure to remove dirt and dust from the imprint surface before performing imprinting.
For test imprinting, it is advisable to use materials with no scratches or stains.
Some material may cause scratches and stains on the head cap during imprinting, which may affect the imprint
quality. Scratches and stains on the material may also damage the head cap and result in poor imprint quality.
Therefore, before performing imprinting, we recommend you perform test imprinting with materials without
any scratches or stains.
2.
Load the material on the grid table.
A
Attach the base unit to the machine.
"
P.37 "Installing/Removing the Base Plate"
IMPORTANT
Attach the base unit in such a way that suits the thickness (height) of the material to be imprinted. If the
configuration is not suited for the material, the imprint quality will be low and the machine may become
damaged.
"
2
Imprinting
61
