Preparing for Imprinting
When not using the base unit
If the imprint surface of a material is set within the imprintable area up to 70 mm (2.8 in.) from the tip of
the head cap (area reached by the marking pin), material with a thickness (height) equal to or greater than
those listed above can also be imprinted.
Head cap
70 mm (2.8 in.)
Area that can be imprinted
80 mm
(3.2 in.)
118 mm (4.6 in.)
(Distance from machine)
* Securing the grid table is not possible if the base unit is not used. In addition to placing a support to
keep the material horizontal, use commercially available tape or some other means to secure the grid
table to the working surface.
* The imprint position alignment accuracy decreases when the base unit is not used. Perform a test
imprint and fine-adjust the position before imprinting for production.
"
P.106 "Imprinting Thicker (Taller) Material"
2
Imprinting
44
