Imprinting
If you’re performing imprinting while using a head cap, this completes the loading of the mate
-
rial. Proceed to P.66 "Making Imprints".
If you are not using a head cap, go to Step
3.
Using the head cap is usually recommended.
• When the head cap is used, the machine automatically tracks the surface height of the material and sets
the position of the head. Imprinting is also possible on curved surfaces. (There is an upper limit to the
height that can be tracked.)
"
P.47 "Conditions for Material When Imprinting Curved Surfaces"
• Imprinting without a head cap is limited to material with an even imprint surface placed horizontally.
3.
Fix the height of the head. (When no head cap is used)
A
Press the Power/Movement button with the head cap attached.
The head moves and stops at the position where the tip of the head cap sits on the surface of the
material.
IMPORTANT
If no head cap is being used, be sure to attach a head cap at this time. If the head cap height is not
set correctly, the desired imprint results may not be obtainable. The head may also become dam-
aged, or the material may become scratched.
B
Loosen the head's stopper.
Rotate the knob once.
Loosen
2
Imprinting
64