Starting Cutting
20
Chapter 2 Cutting
Using a hexagonal driver, alternately tight-
en the screws in two locations little by little.
Workpiece with Pin (L)
Procedure
Close the front cover, and turned the power switch on.
After the initial operation is completed, open the front cover.
Insert the workpiece with pin into the mounting part.
Tighten the mounting screw (L) with a
hexagonal screwdriver (M).
Mounting screw (L)
Workpiece with pin (L)
Align the dent with the
position of the screw hole.
Summary of Contents for DWX-4
Page 53: ...R6 171006 FA01214...
