Periodic Maintenance
37
Chapter 3 Maintenance
2.
Clean the inside, and apply the grease.
Clean the inside.
If cutting waste collect inside, remove them with a dust collector. Remove cutting waste on the shaft with a dust
collector or a commercially available brush.
Apply a thin layer of grease to the drive screws and the shafts shown in the figure below.
If the grease on the surface of the shaft is dried, apply a thin layer of the attached grease to the surface of the shaft.
The shaft and drive screws to be maintained: to
Important Note
Do not manually move the movable portions of the spindle unit, etc. by force. Since the grease
will spread as the machine is used, there is no need to apply it to portions other than the visible
one. Wipe off the grease if it adheres to portions other than the shaft.
Grease application stick
Grease
Look in from underneath.
Summary of Contents for DWX-4
Page 53: ...R6 171006 FA01214...
