26
Preparing for operation
Raking wheel
pitch
The raking wheels can be inclined transversely on the chassis. The ra-
king wheel is set horizontally ex-factory. If the fodder is not picked up
cleanly on one side of a raking wheel, you can improve the raking qua-
lity by adjusting the raking wheel pitch.
The raking wheel pitch is adjusted as follows:
> Lift out the implement complete with control device
> Switch off and secure the tractor
Close the ball valve
Close the ball valve before setting. If the ball valve is open and there
is an operating error, the implement can lower itself and cause serious
injuries.
> Close the stop valve on the hydraulic coupling for lifting and lo-
wering
> Release the three screws only slightly
> Adjust the axle as required by turning the adjusting screw
> Retighten the screws again
Tine anti-loss de-
vice [+]
For a good swath deposit both tine shanks must run parallel to one
another. This must also be ensured after fitting the tine anti-loss de-
vice.
85 Nm
3 M12 screws
Adjusting screw
Tine anti-loss device
All manuals and user guides at all-guides.com
