Denso SE1-BB, User Manual, Page: 27 / 86

14
Chapter 4 Configuring Scanner Parameters
You can customize the scanner by modifying communications, code type, and other scanner parameters in two ways, either
with the Bar-coded parameter menu or the configuration software Scan Tune App*. These parameters retain their settings
even when the power is off.
(1) The Bar Code symbols in the Bar-coded parameter menu can be scanned to set scanner parameters by pressing the trigger
switch.
(The Bar-coded parameter menus for scanners are given in Chapter 11.)
(2) Settings are possible on your computer using the configuration software (Scan Tune App)*. It is recommended that the
scanner be configured as a master.
(This software also offers batch-process Bar Code symbols ready for scanning by scanners in the field.)
Note:
· Customizing the scanner with the configuration software or batch-process Bar Code symbols breaks the Bluetooth
®
wireless link, so it is necessary to establish the link again after customizing. To prevent the Bluetooth
®
wireless link
from getting broken, select the “No slave/master configuration change” parameter for the item “Configure the
scanner as master or slave.”
· When the “End operation” parameter is selected with the scanner, parameters cannot be set. So, before starting
parameter setup, be sure to scan the “Start operation” Bar Code symbol. See Chapter 3 for details on the “Start
operation” and “End operation” parameters.
· The configuration software is not available via the HID (Human Interface Device) Profile.
· If the battery voltage drops, an error beep is sounded to indicate that parameters are not retained. Replace with a fully
charged rechargeable battery or a new LR6 (AA) alkaline battery before setting the parameters.
*The configuration software (Scan Tune App) is available as free downloads from our website at