35
Chapter 8 Beeper, Indicator LED, Vibrator and Marker Beam
8.1 Beeper
(1) Beeping
The scanner emits a short or long beeps, once or a couple of times as described below.
The beeper emits
a short beep
when:
- the scanner has read a code successfully,
- code data read matches the master data in the data verification mode,
- the scanner has read a split QR Code symbol,
- data transfer is started by the data retransfer function or specific character transfer function,
- readable codes are switched by the readable code switching function,
- the "Start setting" or "End setting" QR Code symbol is read (3 beeps) or the parameter setting QR Code symbols are
read (1 beep) from the QR-coded parameter menu (given in Chapters 13 and 14),
- the configuration software (ScannerSetting_2D) starts up or accepts new settings (3 beeps),
- the scanner has read a batch-process QR Code symbol generated with the configuration software (3 beeps),
- a Bluetooth
®
wireless link is established, or
-
the charge of the battery cartridge has lowered, turning the scanner off (5 beeps, slightly longer).
The beeper emits
a long beep
when:
- code data read does not match the master data in the data verification mode,
- the scanner has read split QR Code symbols in the edit mode to the point that the accumulated data exceeds 8
kilobytes,
- a master code has the wrong number of digits during entry of master data,
- a code other than a parameter setting code is read from the QR-coded parameter menu during a parameter setting
sequence
-
a transmission error or timeout has occurred during communication with the configuration software
(ScannerSetting_2D),
- a communications error has occurred,
- an invalid control command is received,
- the previously sent data is not available at the time of data retransfer (using the magic key),
- a Bluetooth
®
wireless link is broken,
- transfer of communications adapter parameter settings is ended normally (1 beep) or abnormally (3 beeps), or
- the scanner has failed to save the parameter settings entered with the QR-coded parameter menu or the configuration
software.
- the encryption key of data read does not match the one configured in the scanner in SQRC scanning (when the "data
transmission after mismatch of encryption key" is disabled).
You can disable the beeper using the QR-coded parameter menu or configuration software (ScannerSetting_2D). In
any of the following cases, however, the beeper sounds regardless of that beeper setting:
- when the scanner is being customized with the QR-coded parameter menu,
- when the scanner receives a beeper-ON command from the host computer,
- when the configuration software (ScannerSetting_2D) starts up or accepts any new setting,
- when a batch-process QR Code symbol is read,
- when the Bluetooth wireless link is established or broken,
- when the charge of the battery cartridge has lowered,
- when the scanner has failed to save the parameter settings, or
- when transfer of communications adapter parameter settings is normally ended.
