- 50 -
[2] REVERSE (Mirror image 2D code reading function)
Mirror image code is a code viewed from a reversed side of a 2D code,
and can be read by setting the “REVERSE” to “ON”. (default: OFF)
Note
Enabling the mirror image 2D code reading may increase reading time for 2D codes.
[3] DECODE LEVEL (Acceptable code quality level)
The decode level is selectable from 1 to 9. (default: 4)
Lowering the level increases the code reading efficiency, however, misreading probability of poor-quality codes
(broken or dirty bars) also increases. Raising the level decreases the code reading efficiency, and also
decreases misreading probability of poor-quality codes.
[4] LIGHT (Light mode)
Sets the light mode.
0
: AUTO (default)
1
: Always ON
2
: Always OFF
[5] SCAN MODE
Selects the scan mode either “NORMAL” or “POINT”.
NORMAL
: Normal read mode (default)
POINT
: Point Scan mode
The point scan mode is used to read a code by aiming at the center cross section of the leaser light marker. A
code cannot be read in the point scan mode, if there is no code within the cross section, or if unable to detect
the marker due to external light, and so on. The point scan mode can be used only when the laser light marker
is enabled and the normal read mode is selected.
[6] MARKER
Sets whether the laser light marker illuminates or not, when a trigger key is pressed.
0
: Normal mode. The laser light marker illuminates during barcode reading. (default)
1
: Always ON. The laser light marker Illuminates during code reading, and stays illuminate for the first 30
seconds until the code is read.
2
: Always OFF. The laser light marker never illuminates.
Note
Setting to “Always ON” increases the power consumption, and may shorten the
operation time as compared to the other two settings.
Changing the settings is not recommended unless necessary.
