0
Get
ting Star
ted
Connections
Pla
ybac
k
Remot
e Contr
ol
ZONE2
Inf
or
mation
Tr
oubleshooting
Specifications
ENGLISH
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey
™
Auto Setup)
STEP5 Check
8
Use
ui
to select
the item you want
to check, then press
ENTER
.
The measurement result
confirmation screen is
displayed.
Speaker Config. Check
Distance Check
Channel Level Check
Crossover Freq. Check
Subwoofer or other speakers may be set to a value that does not
correspond to the actual distance.
b
9
Press
RETURN
.
If you want to check another item, so repeat step 8.
10
Press
i
to select “Next
1
Store”, then press
ENTER
.
STEP6 Store
11
Select “Store” then
press
ENTER
.
“Now Storing... Please
wait.” is displayed while
the results are being
stored.
NOTE
Do not turn the power off while the settings are being stored.
12
When the screen
shown on the right
appears, unplug the
setup microphone
from the AVR-990
SETUP MIC jack.
Exiting the GUI Menu
Press
MENU
while the GUI menu is displayed.
The GUI menu display disappears.
n
STEP3 Measurement
5
Move the setup
microphone to
the 2nd position,
use
ui
to select
“Measure”, then
press
ENTER
.
Measurements for the
2nd position begin.
To skip this step, select “Next
1
Calculation” and proceed to
STEP4 .
b
6
Perform Step 5
repeatedly for the
3rd, 4th, 5th, and 6th
measurements.
When measurements
of the 6th position
are completed,
“Measurements
finished.” is displayed.
To skip this step, select “Next
1
Calculation” and proceed to
STEP4 .
Measure at a total of 6 positions, including the main listening
position and positions around it. It is possible to stop the settings
with five positions or fewer, but for better results we recommend
measuring at 6 positions.
b
b
STEP4 Calculation
7
On the STEP3
screen, use
ui
to select “Next
1
Calculation”, then
press
ENTER
.
Analysis begins.
Analysis takes several minutes to complete.
The time required for this analysis depends on the number
of speakers connected. The greater the number of speakers
connected, the longer analysis will take.
b
If there is a disparity between the results and the connection status,
or if an error message is displayed, check the error message against
the errors listed in the “Error Messages” section (
v
page 31) and
perform Audyssey Auto Setup again.
If the result still differs from the actual connection status after
remeasurement or the error message still appears, it is possible that
the speakers are not connected properly. Turn the AVR-990 off, check
the speaker connections and repeat the measurement process from
the beginning. Turn the AVR-990 off, check the speaker connections
and repeat the measurement process from the beginning.
If you change a speaker position or orientation, perform Audyssey
Auto Setup again to obtain optimal equalizer correction.
•
•
•
NOTE
After performing Audyssey Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey™ Auto Setup again.
13
Select “Exit” and then press
ENTER
.
Remote control operation
buttons
:Displaying the menu
Cancel the menu
:Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting
:Return to previous menu
Set
tin
g
s
