Delta Ultron DPM Series, User Manual

Page: 94 / 264

5 - 6
Ultron DPM series
3
For 1000kW UPS, there is a knockout panel at the left side of the three power
modules, which are installed at the right-hand side of the UPS system cabinet, and a
knockout panel at the right side of the one power module, which is installed at the left-
hand side of the UPS system cabinet. See
Figure 5-3 .
For 1250kW UPS, there is a knockout panel at the left side of the three power
modules, which are installed at the right-hand side of the UPS system cabinet, and a
knockout panel at the right side of the two power modules, which are installed at the
left-hand side of the UPS system cabinet. See
Figure 5-3 .
Please remove the knockout panels shown in Figure 5-3 . The locations where you
remove the knockout panels are the places that you can route the two provided
D-SUB15 communication cables to connect the UPS system cabinet and the power
modules. For relevant information, please refer to
2
and
6
.
1250kW UPS’s Power Modules
Knockout
Panels
(Rear)
(Front)
(Rear)
(Front)
Power Modules (at the UPS System
Cabinet’s Left-hand Side)
Power Modules (at the UPS System
Cabinet’s Right-hand Side)
NOTE:
For 1000kW UPS, there is no this
power module. However, the locations and
total Q’ty of the knockout panels are the same
as 1250kW UPS. Thus, in
Figure 5-3 ,
only the illustration of 1250kW UPS’s
power modules is taken for example.
(Figure 5-3: Location of the Power Modules’ Knockout Panels)