Chapter 4 Parameters
|
4-84
Revision July 2008, EG03, SW V1.06
Content Address
Function
2108H
Output power (XX.XXKW)
2109H
Feedback Signal
210AH
Feedback Signal (%)
210BH
Estimated torque ratio
210CH
User output (Low) uL 0-99.99
210DH
User output (High) uH 0-9999
210EH
PLC Time
210FH
Reserved
3.6 Exception response:
The AC drive is expected to return a normal response after receiving command messages
from the master device. The following depicts the conditions that no normal response is
replied to the master device.
The AC drive does not receive the messages due to a communication error; thus, the AC
drive has no response. The master device will eventually process a timeout condition.
The AC drive receives the messages without a communication error, but cannot handle it,
an exception response will return to the master device and an error message “CExx” will
display on the keypad of AC drive. The xx of “CExx” is a decimal code equal to the
exception code that will describe below.
In the exception response, the most significant bit of the original command code is set to 1,
and an exception code explains the condition that caused the exception is returned. An
example of exception response of command code 06H and exception code 02H:
ASCII mode:
RTU mode:
STX ‘:’
ADR 01H
‘0’
CMD 86H
ADR 1
ADR 0
‘1’
Exception
code
02H
‘8’
CRC CHK Low
C3H
CMD 1
CMD 0
‘6’
CRC CHK High
A1H
‘0’
Error code
‘2’
‘7’
LRC CHK 1
LRC CHK 0
‘7’
CR
END 1
END 0
LF
Summary of Contents for AC Motor Drive VFD-G
Page 1: ......
Page 2: ......
Page 3: ......
Page 141: ...Chapter 4 Parameters 4 90 Revision July 2008 EG03 SW V1 06 This page intentionally left blank...