10.
Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot
If there is a release tab on the card slot, pull the release tab.
11.
Before you rotate the card retainer back into place, ensure that:
l
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of each card or filler bracket fits around the alignment guide.
12.
Rotate the card retainer until it snaps into place.
1 bracket within slot
2 bracket caught outside of slot
3 card fully seated
4 card not fully seated
NOTE:
For extra security, remove the alignment guide (an upside-down screw) and screw it in right side up to secure a card.
1 card retainer
2 alignment bar
3
alignment guide
NOTE:
For extra security, remove the alignment guide (an upside-down screw) and screw it in right side up to secure a card.
4 filler bracket
NOTICE:
Do not route card cables behind the cards. Cables routed behind the cards could cause damage to the equipment.
Summary of Contents for Precision Workstation 690
Page 161: ...Back to Contents Page ...
