Installing heat sink assembly
1
Align the screws of the heat sink assembly with the holders on the system board.
2
Place the heat sink assembly on the processor.
3
Replace the captive screws (6+/-1) to secure the heat sink assembly to the system board.
NOTE:
Tighten the screws based on the order given in the system board.
4
Connect the heat sink assembly cable to the connector on the system board.
5
Close the front panel door.
6
Install the:
a
b
7
Follow the procedure in
After working inside your computer
.
Processor
Removing the processor
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
3
.
4
Remove the:
5
To remove the processor:
a Release the socket lever by pushing the lever down and out from under the tab on the processor shield [1].
b Lift the lever upward and lift the processor shield [2].
c Lift the processor out of the socket [3].
CAUTION:
Do not touch the processor socket pins, they are fragile and can be permanently damaged. Be careful not
to bend the pins in the processor socket when removing the processor out of the socket.
Disassembly and reassembly
37
Summary of Contents for OptiPlex 5055 Tower
Page 1: ...Dell OptiPlex 5055 Tower Owner s Manual Regulatory Model D18M Regulatory Type D18M004 ...
Page 12: ...4 Lift the front bezel to remove it from the computer 12 Disassembly and reassembly ...
Page 44: ...b Slide and lift the system board away from the computer 2 44 Disassembly and reassembly ...
