FInstalling SD card reader
1
Insert the SD card reader into the slot on the system board.
2
Replace the screw(6+/-1) to secure the SD card reader to the front panel door.
NOTE:
The screw holder is beneath the SD card reader.
3
Connect the SD card reader cable to the connector on the system board.
4
Close the front panel door.
5
Install the:
a
b
6
Follow the procedure in
After working inside your computer
.
Memory modules
Removing memory module
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
3
.
4
To remove the memory module:
a Pull the clips securing the memory module until the memory module pops up.
b Lift the memory module from the connector on the system board.
Installing memory module
1
Align the notch on the memory module with the tab on the connector.
2
Insert the memory module into the connector.
3
Press the memory module until the memory module retention tabs click into place.
4
Close the front panel door.
5
Install the:
a
b
6
Follow the procedure in
After working inside your computer
.
Disassembly and reassembly
25
Summary of Contents for OptiPlex 5055 Tower
Page 1: ...Dell OptiPlex 5055 Tower Owner s Manual Regulatory Model D18M Regulatory Type D18M004 ...
Page 12: ...4 Lift the front bezel to remove it from the computer 12 Disassembly and reassembly ...
Page 44: ...b Slide and lift the system board away from the computer 2 44 Disassembly and reassembly ...
