Dell Inspiron 1501 - Turion X2 TL-60 2GB DDR2, Owner'S Manual

Page: 96 / 166

96
Adding and Replacing Parts
NOTE:
If the memory module is not installed properly, the computer may not boot properly. No error message
indicates this failure.
4
Ground yourself and install the new memory module:
a
Align the notch in the module edge connector with the tab in the connector slot.
b
Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it
clicks into place. If you do not feel the click, remove the module and reinstall it.
5
Replace the memory module cover.
NOTICE:
If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may
damage your computer.
6
Insert the battery into the battery bay, or connect the AC adapter to your computer and an
electrical outlet.
7
Reinstall the hard drive. See page 92.
8
Turn on the computer.
As the computer boots, it detects the additional memory and automatically updates the system
configuration information.
To confirm the amount of memory installed in the computer, click the Start button, click Help and
Support , and then click Dell System Information .
Modem
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide .
1 notch 2 tab
1
2
book.book Page 96 Friday, December 21, 2007 3:22 PM