Steps
1
Orient the NDC so that the Ethernet connectors fit through the slot in the back panel.
2
Align the captive screws at the back-end of the card with the screw holes on the system board.
3
To ensure that the connector on the card is in contact with the connector on the system board, press the touch point on the card.
4
Tighten the two captive screws to secure the NDC to the system board.
5
Install the expansion card riser 3.
Figure 54. Installing the NDC
1
captive screw socket (2)
2
connector on the system board
3
captive screw (2)
4
touch point (2)
5
NDC
6
back panel slots for Ethernet connectors
Next steps
Follow the procedure listed in the After working inside your appliance section.
Processors and heat sinks
Use the following procedures when:
•
Removing and installing a heat sink
•
Installing an additional processor
•
Replacing a processor
NOTE:
To ensure proper cooling, you must install a processor blank in any empty processor socket.
Installing and removing components
97
