Dell EMC ECS EX300, Installation Manual

Page: 55 / 56

b. Insert the free end of the securing strap into the slot on the ratchet
mechanism. Pull the ratchet handle down to tighten the securing strap
around the lift and the enclosure.
Figure 28 Tightening the Straps
1 2
CL5429
c. Make sure the enclosure is securely strapped to the lift before moving. Use
the cordless drill to raise the arm to lift the enclosure from the support table.
Once the enclosure is supported by the arm, lower the arm to the lowest
point that still permits travel.
This allows the enclosure to be moved with minimal danger of tipping over.
6. Unlock the casters by lifting up on the locking tabs and move the enclosure as
required.
Figure 29 Unlocking the Casters
CL5424
7. Move the enclosure to the support table. Use the drill to raise or lower the
enclosure above the support table. Move the enclosure over the support table,
and use the drill to lower the enclosure onto the table.
Mechanical lift
Using the lift on an Enclosure more than 49" above the floor 55