Del Medical EPEX Omniflex IV, Service Manual

Page: 61 / 238

EPEX/Omniflex IV System Service Manual
Installing the System Hardware 3-13
Room Layout
For an illustration of a typical room layout, refer to Figure 3-9 on
page 3-17. However, for your installation, refer to the final site planning
and the Radiographic Table to OTC drawings for specific details regarding
the actual placement of equipment, including the floor location of the table.
The Radiographic Table to OTC layout drawing shows the preferred install
location of the OTC rails in relation to the table. The dimensions in the
Radiographic Table to OTC layout drawing allows positioning the OTC in
A, B, or C detent SID setups.
Determining which detent setup(s) the customer will use enables you to
optimize the room usage.
Figure 3-6.
Setup Detent A
“A” SETUP DETENT AND SWITCH CAM POSITIONS
TABLE CENTER LATERAL DETENT
40”/44” A SETUP SID SWITCH CAM
TABLE CENTER LATERAL
SWITCH CAM
72” A SETUP SID SWITCH CAM
TABLE C.L.
WALL “A” SETUP BUCKY LATERAL
CENTER SWITCH CAM
WALL “A” SETUP BUCKY LATERAL
CENTER DETENT
DK20_137.cdr