DFDVR2
24
4-5-2: PAN/TILT SETUP
COMMAND SETUP
1. CHANNEL
Select PTZ channel.
2. MODEL
Select PTZ protocol.
3. PTZ ID
Select PTZ ID.
4. BUADRATE
Select Baud Rate of PTZ control code.
5. CMD DELAY
Set up a delay time to run the command.
6. COMMAND
Pick up PTZ CMD.
7. LENGTH
Set up the length of PTZ control code.
8. CODE
The control code of PTZ CMD.
SPEED SETUP
1. PAN SPEED
Set the PANing speed.
2. TILT SPEED
Set the TILTing speed.
3. ZOOM SPEED
Set the speed of ZOOM IN/OUT.
4. FOCUS SPEED
Set the speed of FOCUS NEAR/FAR.
4-5-3: SPOT SETUP
This menu allows you to change settings for the
SPOT video out. The spot video out is designed
to only display a camera channel when motion
is detected. To use the SPOT function, you must
connect an external monitor to the SPOT video out
jack located on the back of the DVR.
1. SWITCH INTERVAL
- Channel switching interval time (Range:01 ~ 99 sec).
2. MOTION POP UP
- Turns the MOTION detection pop up ON or OFF.
3. EVENT POP UP DURATION
- If events such as ALARM or MOTION happen on several
channels at the same time, Channel 1 has the first priority to pop up. For example, if
events happen on channel 1, channel 2 and channel 4 at the same time, channel 1
pops up. If the motion disappears on channel 1, then channel 2 pops up for the duration
that you set. However, even though motion happens on channel 1 again within the
duration, Channel 2 still displays. If motion on Channel 1 keeps on going even after the
duration of channel 2, Channel 1 pops up again. Setting the duration to a shorter time
will make the channel pop ups more immediate. Setting the duration to a longer time
may make it easier to see what is happening on each camera.
