DFDVR2
5
SECTION 2: INSTALLATION
2-1: CAMERA INSTALLATION
Things To Consider Before You Install Your Cameras
• Camera(s) should be installed between 8 and 13 feet above the area to be monitored.
• Ensure there are no obstructions in the camera’s view, to maximize viewing area.
• Ensure that the sunshade is positioned to avoid glare and position cameras away from
direct sunlight.
• Decide whether the camera will be wall-mounted or sit on a desk/table top. If wall
mounting, use the mounting hardware in the package. The camera can be adjusted for
either mounting scenario by rotating the camera to the required position.
• Each camera comes with 60 feet of extension wire. Please make sure that you mount
the cameras no more than 60 feet from the DVR.
• We recommend using a surge protected power bar and/or an Uninterruptible Power
Supply (UPS) to power the DVR and camera system.
Mounting
1. Screw each mounting bracket into each camera’s mounting hole, turning it clockwise.
2. Mount each camera in the desired location no more than 60 feet from the DVR
unless you have purchased additional wiring. You may wall mount or desk mount
these cameras.
3. Adjust cameras to the desired viewing angles.
Wiring The Cameras
Follow these instructions for the installation of each camera
1. Plug the 4pin din female connection
on the camera into the 4 pin din male
connection on the 60 foot extension wire.
2. Plug the camera’s power supply into the
power jack located on the 60ft extension wire.
3. Plug the camera’s power adapter into an
AC outlet.
4. Attach the BNC to RCA connectors to
the camera inputs and the monitor
outputs on the back of the DVR.
5. Connect the extension wire’s male RCA
plug to CAMERA IN port for channels 1~4.
1
2
3
4
5
