48
more detailed information and the setup of each HDD.
Please note that if the total
alarm record size is zero, the alarm video/audio will be recorded in the normal record
partition. If the total normal record size is zero, the normal video/audio will be
recorded in the alarm record partition.
Auto Overwrite
– automatic overwrite of the recorded video/audio from HDD#1
when the Alarm/Normal Record disk drive capacity reaches the end of the last HDD.
If Auto Overwrite is disabled and the Alarm/Normal Record disk drive capacity
reaches the end, the system will not overwrite the recorded video/audio, and hence
not record Alarm/Normal video/audio, until the user presses the
Alarm Reset
button.
HDD Full Action
– actions when Alarm/Normal Record disk drive capacity reaches the
end of the last HDD.
Duration
– response duration to define at most how long (in seconds) the Alarm Out
relay and the Buzzer will keep being triggered after the corresponding partition,
Alarm Record or Normal Record, is full. The value - means forever.
Alarm Out
– to define which Alarm Output will be triggered when this event is
triggered. Alarm Output Source Setup up to 32 alarm outputs can be selected and the
definitions are similar to alarm inputs.
Buzzer
– to activate the internal Buzzer or not when the corresponding partition,
Alarm Record or Normal Record, is full.
Log
– to log to event logs or not.
– to send the event e-mail to remote station or not. The e-mail will be sent to
the predefined receivers when the event is triggered.
Summary of Contents for 16-CH
Page 77: ...77 Edge ...
Page 78: ...78 ...
Page 79: ...79 ...
Page 102: ... 102 7 Set Time Based Refresh 8 Click on OK button to save the settings ...