DEC DECNIS 600, Installation And Service Manual

Page: 75 / 288

Figure 5–1 Network Interface Card States
ATTENTION
HOTSWAP
FAULT
The Network Interface Card is disabled
(switch is down). Follow the procedures in
Section 5.8 to enable the card.
Either:
– The card is not installed correctly
– There is a fault on the card or the slot
Follow the procedures in Section 5.10.
LKG–5660-91I
No LED lit
The module self-test has failed. There may
be a fault on the Network Interface Card.
Follow the procedures in Section 5.10.
NIC
State Action LEDS
The Network Interface Card is running, but
not all ports on the card are usable.
Follow the procedures in Section 5.10.
Testing in
progress
Loading
The module self-test is running on the
card (1 flash per second).
The Network Interface Card is either waiting to
load or the software is loading.
Refer to Section 5.11.
(flashing)
(flicker)
Adding Network Interface Cards to a Running System 5–13