DEC DECNIS 600, Installation And Service Manual

Page: 21 / 288

1.3.4 Access
The following access is required so that the unit can be unpacked and installed:
• Remove any door on the front of the rack, or secure the door open.
• Clear a space of approximately 2 m (6.5 ft) at the front of the rack.
You will also need access to the rear of the rack to install the support brackets.
If possible, remove the rear door. If the rear of the rack is against a wall, make
sure that you can gain access from the front of the rack.
1.3.5 Position of the DECNIS 600
The DECNIS 600 can be installed in any position in the rack that satisfies the
following requirements:
• The position must conform to the published safety standard EN60950,
UL1950, CSA 950. This standard specifies important information about
the stability of rack mounted equipment.
• The position must satisfy the environmental requirements specified in
Appendix B.
If other equipment is installed in the rack, you should also check that
the DECNIS 600 does not affect the environmental requirements of that
equipment. For example, the DECNIS 600 should not be installed in a position
that restricts the air flow required for cooling other equipment.
1.4 Kit Contents
Figure 1–1 shows the contents of the kit as they are packed in the DECNIS
600 carton.
Note
When you unpack the DECNIS 600, save the packaging materials and
carton in case you need to return any items.
If there are any items missing from the kit, or if any of the contents are
damaged, contact your Digital representative.
Preparing to Install the System 1–3