dbx Zone Pro 1260, User Manual

Page: 23 / 75

Software Operation
Section 3
ZonePRO ™
15 ZonePRO ™ User Manual
Edit - Source Selection
- A ZC-3, ZC-4, ZC-8, or ZC-9 can be used to provide
source selection. Select the desired ZC type and make sure it has the correct
ID number. For a ZC-3, ZC-8, or ZC-9 for each switch position, select the cor-
responding source. For a ZC-4, select the switch position 0-15 and choose the
corresponding input source (see ZC-4 switch positions within the Appendix).
Edit - Page Routing
- For a ZC-3, only four zones or groups of zones can be
switched between. A ZC-4 can switch between 16 zones or groups of zones.
Like a ZC-3, the ZC-7 only has four positions, so it will only support up to four
zones or groups of zones, but it does have momentary switches that can be
used in a push-to-call fashion, where each switch must be pushed and held to
route the page to that zone or group of zones. Once you have performed all
your zone controller configurations, click
NEXT
to move to the Routing
Configuration.
3.3.4 Source Association
The Source Association page allows selection of the main Source, the Priority override source,
the Page source, and the output level for each of the output zones. The Source ZC page
appears as follows:
3.3.5 Routing and Zone ZC Association
The Routing configuration Page allows selection of the main Source, the Priority override
source, the Page source, and the output level for each of the output zones. If Zone
Controllers are used for either source selection or level control, these should be selected in
the Source or Level pulldown menu. If zone controllers are being used for Page Steering
select None in the Page menu for those outputs unless a microphone is always paging to that
zone in addition to the page steering.