9
Figure 7 - i-Safe™ RFID Tag
A
Wrap-Around Cover
B
i-Safe™ RFID Tag
C
Product Labels
A
B
C
Figure 8 - Stitched Impact Indicator
A
A
Stitched Impact Indicator
6.0 MAINTENANCE, SERVICING, AND STORAGE
NOTE:
Only Capital Safety or parties authorized in writing may make repairs to this equipment.
6.1 WASHING
INSTRUCTIONS:
Washing procedures for the ExoFit NEX™ Full Body Harness are as follows:
Step 1.
Spot clean the ExoFit NEX™ Full Body Harness with water and a mild soap solution. The harness
may be laundered by using a bleach-free detergent. Water temperature for wash and rinse must
not exceed 70° C.
Step 2.
The harness may be laundered by using a bleach-free detergent. Water temperature for wash and
rinse must not exceed 70° C.
Step 3.
The harness and pads may be air dried or tumble dried on low heat not exceeding 90° C.
IMPORTANT:
Use a bleach-free detergent when washing the harness and pads. Fabric softener or dryer
sheets SHOULD NOT be used when laundering and drying the harness and pads.
NOTE:
More information on cleaning is available from Capital Safety. If you have questions concerning the
condition of your harness, or have any doubt about putting it into service contact Capital Safety.
6.2 STORAGE:
Store the ExoFit NEX™ Full Body Harness in a cool, dry, clean environment out of direct sunlight.
Avoid areas where chemical vapors may exist. Thoroughly inspect the full body harness after extended
storage. Adjust buckles to full extension and remove padding (where applicable) to facilitate drying.
Thouroughly inspect the full body harness after extended storage.