58 /87
5.3.10.3
RS-485 ADDRESS MENU
In this menu it is possible set the RS-485 address in case the unit is used as slave device in a bus
system (for example a high power transmitter or a 1+1 system).
Navigate to the menu RS485 Address with UP or DOWN key.
Fig. 5.64 – Set RS-485 address page
To change the RS-485 address, press the OK key to enter the program mode (blinking arrow in
second row on the right). Press UP or DOWN keys to select the desired value. Press OK key to
confirm or ESC key to exit routine without saving.
5.3.10.4
NETWORK PARAMETERS
These are read only menus, the IP address and Netmask are set directly from webpage if webserver
option is available.
Fig. 5.65 – Unit IP address page
In this menu the actual unit IP address is showed.
Fig. 5.66 – Unit netmask page
In this menu the actual netmask is showed.
