32
CHAPTER 5.
USAGE
Figure 5.12.: Example of Remote Console settings
The Power Control panel enables access to the most important external buttons of your host system
besides of the keyboard. These buttons are the reset and the ATX power button.
The power button is the representation of the ATX power button on your host system. It is used to
switch on and off the power supply. The ATX power button knows two operation modes: pressing
it shortly and pressing it for about 4 seconds. As shown in Figure
5.14
on the next page these two
modes are supported separately. Table
5.5
on page
34
explains the different effects.
Note: The prerequisite for the remote power/reset button to work is a correct installation
of LARA. The additional cabling as described in Section
3.3.3
on page
13
must be properly
connected.
External power option
If an external power option is enabled the power control will look like shown in Figure
5.15
on the
next page.
The upper half is used to switch the power for the KVM port currently active. Use the KVM
settings (Section
5.4.4
on page
35
) to assign a port of the external power control to a KVM port.
Summary of Contents for LARA
