Daxten LARA, Manual, Page: 28 / 89

16 CHAPTER 4. CONFIGURATION
Table 4.2.: Serial line parameters
Parameter Value
Bits/second 115200
Data bits 8
Parity No
Stop bits 1
Flow Control None
After you have connected your terminal to LARA, you will see the following message on the host’s
monitor or in the terminal:
LARA (c) Peppercon AG 2002
For initial IP configuration login as "config". Press F10 to resume.
192.168.1.22 login:
Please enter ’config’ as login name. There is no password required. As you go along you will see
the following lines, which you have to answer or to which you may provide the default value by
pressing
< Enter > . The default value is shown in square brackets.
Enable DHCP (yes/no) [yes]:
IP [192.168.1.22]:
NetMask [255.255.255.0]:
Gateway (0.0.0.0 for none) [0.0.0.0]:
Enable IP Access Control (yes/no) [no]:
After logging in, you must disable DHCP. You may change the IP address, net mask and gateway
address. The input may be left empty and you can quit with
< Enter > to accept the pre-assigned
value. In order to contact LARA from outside of your LAN you need to configure a gateway. If
you want to remove an already configured gateway, enter 0.0.0.0.
The last question ‘Enable IP Access Control’ allows you to switch IP packet filtering on or off. It
is mainly intended to re-enable access to LARA after a faulty IP access control configuration has
been activated. Refer to Table
5.18 on page 57 for more information about IP access control.
After entering all the values, you will see the welcome message again.
4.1.3. Mouse, Keyboard and Video configuration
The correct operation of the remote mouse depends on two settings which will be discussed in the
following subsections. In case the remote mouse doesn’t work properly at least one of the following
settings is probably not correct.
LARA mouse settings
The LARA settings for the host’s mouse type and the host’s keyboard type must be correct in order
to make remote keyboard and mouse work properly. Check the settings in the LARA front-end.
See Section
5.4.3 on page 35 for details.