Daxten LARA, Manual, Page: 26 / 89

14 CHAPTER 3. INSTALLATION
10 Mbps Connection
For 10BASE-T Ethernet networks, the Fast Ethernet adapter uses Category 3, 4, or 5 UTP cable.
To establish a 10 Mbps connection, the cable must be connected to a 10BASE-T hub.
1. Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.
2. Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the adapter’s
connector.
100 Mbps Connection
For 100BASE-TX Fast Ethernet networks, LARA supports Category 5 UTP cabling. To establish
a 100 Mbps connection, the cable must be connected to a 100BASE-TX hub.
1. Make sure that the cable is wired appropriately for a standard 100BASE-TX adapter.
2. Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the adapter’s
connector.
Note:
The UTP wire pairs and configuration for 100BASE-TX cable are identical to those for
10BASE-T cable when used with Category 5 UTP cable.
3.3.6. Connecting ISDN
The rear side of LARA contains two RJ-45 connectors. The upper connector, marked as ’ISDN’ is
used to connect LARA to an ISDN network, using a standard ISDN cable.