BIKING
Do never straighten any damaged or bent security
relevant parts like e.g. frame, fork, handlebar,
saddle pillar or pedal cranks, but instead have them
replaced before using this bicycle. There is a risk of
fracture. In case of doubt please consult your daum
electronic dealer.
Is the ergo_bike pedelec in proper state?
Before every trip with the ergo_bike pedelec you
should verify that it is in a faultless state. To that effect
you should carry out the following tests (please read
the complete explanation to each point below in the
corresponding section):
- Is the saddle clamp firmly attached to the saddle?
(see section "Adjusting the saddle")
- Do the brakes operate without fault?
- Is the light system operational?
- Is the rechargeable battery correctly locked in
the battery compartment?
Carry out the following tests at regular intervals:
- Is the tyre pressure correct? (see the section
about "Dismounting and mounting the tyres")
- Is the bike chain in proper condition? (see the
sections "Verifying chain wear" and "Bike chain
tension")
- Are the steering bearing and the pedal cranks
in proper condition? (see the sections "Steering
bearing" and "Pedal cranks")
- Are all the spokes firmly seated? (see
the section
"Spokes")
Safety hints
Verify after a fall or accident that no part is bent or
distorted or damaged (the frame, the handlebar, the
wheel rims, etc.).
If any one of the elements mentioned above is not in
proper operating condition then please avoid using
the bike. The defects must immediately be repaired.
If you can not repair the defect yourself then please
contact your daum electronic dealer.
48
ergo_bike pedelec
