CONFIGURATION
Product Reference Guide
13
Linking the PowerScan™ BT8300 to the BC 8030-BT Cradle
The PowerScan BT 8300 reader can be connected with the PowerScan BC 8030-BT cradle in either of three ways.
After the BC-8030-BT cradle is powered on and connected to the Host, configure the Power Scan BT8300 by reading the
following bar codes in the given sequence as described in each section.
NOTE
Remember: The mandatory condition for establishing a new connection between a BT reader and a
BT cradle is that they share the same security configuration. The connection timeout is 30 seconds.
Four ascending beeps from the reader indicate a successful link, otherwise there are four descending
tones.
Link by Contact
Read the bar codes in sequence as shown in the steps below:
1.
Enter Configuration
Ì$+;Î
2.
Handheld - Cradle
3.
Link by Contact
4.
Exit and Save Configuration
Ì$-?Î
5. Firmly position the reader onto the cradle. The BC 8030-BT cradle will emit a beep and the yellow LED will blink
while the cradle is trying to establish the connection. Four ascending beeps will be emitted, signaling that the BC
8030-BT cradle has been successfully connected to the PowerScan BT8300, and the yellow LED on the cradle
will stop blinking.
6. To connect another PowerScan PBT8300 to the BC 8030-BT cradle, repeat the sequence from steps 1 through
5. One Cradle can connect with a maximum of four readers.
7. Upon completing the connection between the reader and cradle you must set up the correct interface for your
system. Refer to the BC 8030-BT Base Station Charger QRG for information and programming labels, and scan
the appropriate bar code to select your system’s interface type.
END of procedure. YOUR READER IS NOW READY TO READ CODES.
Summary of Contents for PowerScan BT8300 Family
Page 191: ......
